Toilet repair starts with finding where the fault is: the tank, the flush, the drain or the base. A new flapper is a quick fix you can do yourself, but a leak at the base or a cracked tank calls for plumber visits.
Leaks At The Bowl Or Tank
A drip from the bolts under the tank points to the rubber gasket between the tank and the bowl. The weight of the tank and water presses on that gasket, and it wears down over time.
Sometimes the tank bolts work loose as the gasket wears, and tightening them stops the drip. Do not overtighten them, because too much force can crack the toilet. If tightening does not help, toilet tank leak repair means a new gasket and bolts, and the tank has to come off. For the full steps, read about tank seals and bolts. If the whole toilet moves, read about a rocking toilet.
Water inside the bowl is a different leak. It usually means a worn flapper. A few drops of food colouring in the tank will show it in 10 minutes, and our guide to running toilets has the full test.
Weak Or Broken Flush
A weak flush most often comes from the flapper or its chain. The chain should have 1 or 2 links of slack. If it is looser, the flapper cannot lift far enough. A fill valve float set too low can also leave too little water in the tank. If the handle itself is the problem, read about a loose handle. A tank that takes a long time to fill points to the fill valve, so read about slow refills.
The small holes at the top of the bowl can clog with minerals and slow the flush. A deep clog in the drain can slow it too.
Blocked Toilets
For toilet blockage repair, use a plunger with a soft flap on the bottom. A flat sink plunger will not seal well in a toilet.
- Put the plunger in at a 45 degree angle so the cup fills with water.
- Press it over the hole to make a seal.
- Push and pull with slow pulses, since the pull does most of the work.
If the water rises after you flush, turn off the water valve behind the toilet so the bowl does not overflow. If something like a toy or a phone fell in, put on gloves and take it out by hand. To work on the toilet once the water is off, read about emptying the bowl.
If you smell sewer gas, open a window and call a plumber. When more than one drain backs up, read about drains.
When To Replace A Toilet
The U.S. EPA says that when new parts do not stop a leak, it may be time to replace the toilet. Ask a plumber to help put in the new one.
Before You Call
Find the water valve behind the toilet, and turn it off if the bowl is about to overflow. Note where the water is coming from: the tank, the bolts, the base or the drain. That helps a plumber know what to bring.
If more of your plumbing needs work, see every job a plumber can help with in Peterborough.
Why Does My Toilet Leak At The Base?
The seal under the toilet is a wax ring, and it sits on a fitting called a flange. A toilet that rocks on the floor may have a damaged wax ring or a cracked flange. A cracked flange has to be replaced, so call a plumber.
Can A Plumber Fix A Weak Flush?
Yes, a plumber can. They can check the flapper, the chain, the fill valve and the drain. You can check the chain yourself first, since it only needs 1 or 2 links of slack.
When Should I Replace A Toilet?
Think about it when new parts do not stop a leak. A plumber can tell you whether a repair or a new toilet makes more sense.
Who Fixes A Cracked Toilet Tank?
Call a plumber. Turn off the water valve behind the toilet first, so the tank does not keep filling.