East City Plumbing

How To Repair A Toilet Flush Handle

East City Plumbing

How to repair a toilet flush handle depends on what is wrong with it. A handle can come loose, rust or break after years of use and damp air. When yours sticks or needs extra force to flush, it is likely ready to be replaced. If you live near Peterborough, this is a job most people can do in a few minutes.

Check The Chain First

Take the lid off the tank, and look at the chain that runs from the handle arm to the flapper. The chain should have 1 or 2 links of slack.

A chain that hangs too loose cannot lift the flapper far enough, so you get a slow or weak flush each time you push the handle down. When it is pulled too tight, the flapper cannot seal and the toilet keeps running. For more on that, read about a toilet that keeps running.

Swap The Old Handle

If the chain looks right and the handle is still loose or broken, replace it.

  1. Take the lid off the tank, and unhook the chain from the handle arm.
  2. Loosen the nut inside the tank that holds the handle in place.
  3. Pull the old handle and its arm out through the hole in the tank.
  4. Push the new handle through the hole, and put the nut back on.
  5. Hook the chain to the arm, leaving 1 or 2 links of slack.

Watch the nut in step 2. Most handle nuts have a reverse thread, so you turn them clockwise to loosen them. Follow the directions that come with the new handle when you tighten it.

If your tank has the handle on the side, the new one can sit level or point up and down. Pick the way that fits your tank.

Test The Flush

Put the lid back on, and flush. The bowl should clear, and the arm should not touch other parts inside the tank. If the arm hits the lid when you flush, set it lower.

If the arm sits too close to the fill valve, you may need to move the valve a little to make room. Read about the part that refills the tank before you move it.

Which Way Does The Handle Nut Turn?

Most handle nuts have a reverse thread. Turn the nut clockwise to loosen it.

Why Is My Flush Weak After I Changed The Handle?

The chain may be too loose. Leave only 1 or 2 links of slack so the flapper lifts all the way.

Why Does The Toilet Run After I Changed The Handle?

The chain may be too tight, so the flapper cannot seal. Give it a little more slack.

Request A Visit

Tell us what you see and when it started, and say if water is still running, so we know how soon you need help.

Read how we handle your details in our privacy policy.

Online requests are not open yet.