East City Plumbing

Toilet Tank Fill Valve Repair

East City Plumbing

Toilet tank fill valve repair is a job most people can do with a sponge, a bucket and a new valve. The fill valve is the part that lets water back into the tank after a flush. Most valves last 5 to 7 years, and sediment in the water can wear them out sooner. If you live near Peterborough, here is what to check and when to swap it.

The Tank Fills Slowly

Start with the water valve behind the toilet. Make sure it is turned all the way open, and that the water line is not kinked or bent.

When the water supply is fine, minerals or sediment may be clogging the valve. A valve that is more than 5 years old is easiest to replace.

To test the water line, turn off the water and take the line off the bottom of the valve. Point it into a bucket, and turn the water on slowly. If little or no water comes out, the blockage is in the line or the water coming into the house, and a licensed plumber should take a look.

The Bowl Does Not Refill

Sometimes the tank fills fine, but the water in the bowl stays low after a flush. That points to the fill valve as well.

A small tube runs from the valve to the tall pipe in the middle of the tank, called the overflow tube. It sends water down into the bowl after each flush. Take the lid off and check that the small tube is attached and aimed into the overflow tube. If it has come loose, the water goes into the tank instead of the bowl.

If little or no water comes through the tube, the valve may be clogged with minerals, and you may need to replace it.

The Toilet Makes Noise

Most toilet noise comes from the fill valve. A squeal can mean the water has to squeeze through a tight spot, so check that the valve behind the toilet is fully open. A bang when the tank refills is often water hammer, and a new fill valve is the first thing to try. Read about a banging refill if the noise keeps up.

How To Swap The Fill Valve

  1. Turn off the water valve behind the toilet.
  2. Flush, and hold the handle down to drain most of the tank.
  3. Sponge out the water that is left.
  4. Take the water line off, remove the nut under the tank, and lift the old valve out.
  5. Set the new valve in, and tighten its nut by hand only.
  6. Hook up the water line by hand only, with no sealant or tape.
  7. Turn the water on slowly, and watch the tank fill.

Set the height before you tighten anything. If the valve sits too high, it may not shut off, and the tank can run all the time or overflow. If it sits too low, there will not be enough water in the tank, and the flush will be weak. The guide we read says the water level mark should sit about 1/2 inch below the top of the overflow tube.

Keep the small tube clipped above the overflow tube. Pushed down inside it, the tube can siphon water out of the tank.

How Long Does A Fill Valve Last?

Most last 5 to 7 years. Sediment in your water can shorten that.

Why Does My Toilet Fill So Slowly?

Check that the valve behind the toilet is fully open and the line is not kinked. If those are fine, the fill valve may be clogged.

What If No Water Comes Out Of The Line At All?

That points to a problem with your home's water supply. Call a plumber.

Request A Visit

Tell us what you see and when it started, and say if water is still running, so we know how soon you need help.

Read how we handle your details in our privacy policy.

Online requests are not open yet.