How to repair a toilet tank leak starts with where the water goes. Water on the floor under the tank most often means the seal between the tank and the bowl has worn out. Water that slips into the bowl without a flush points to a part inside the tank. If you live near Peterborough, here is how to find the leak and fix it.
Find Where The Water Goes
Look for water pooling on the floor, dripping from the bolts under the tank, or wetting the base of the tank. Any of these means the seal between the tank and the bowl needs to be replaced, along with its bolts.
A leak into the bowl is harder to see. Put a few drops of food colouring in the tank, and wait 10 minutes without flushing. If colour shows up in the bowl, the tank is leaking inside. Flush right after the test so the dye does not stain the tank.
Why The Seal Wears Out
Over time, the weight of the tank and its water squeezes the seal, and the tank can shift when someone leans back on it. A bump while cleaning can move it too. As the seal wears down, the bolts can loosen and let water out.
Tightening the bolts may stop the leak. Do not overtighten them, and do not let the tank touch the bowl, because the porcelain can crack.
Replace The Seal Between Tank And Bowl
If tightening the bolts does not work, replace the seal and its bolts. Seals come in two sizes, 2 inches and 3 inches, so check which one your toilet takes. You will want a second person for this job.
- Turn off the water valve behind the toilet, and flush to drain the tank.
- Put a bucket under the water line, and take the line off the tank.
- Sponge out the water left in the tank.
- Take out the old bolts, washers and nuts, and lift the tank off.
- Set the tank on the closed toilet seat, and pull off the old seal.
- Fit the new seal over the large nut at the bottom of the tank.
- Set the tank back on the bowl, and put in the new bolts and washers.
Have your helper press down evenly on the tank while you tighten the nuts. Switch from one side to the other as you go, so the tank stays level. Stop once it is firm, since too much force can crack the porcelain.
Reconnect the water line by hand only, with no sealant or tape. Turn the water on slowly, and watch the joint between the tank and the bowl as the tank fills.
When The Leak Is Inside The Tank
If the dye test showed colour in the bowl, the seal at the bottom of the tank is the likely cause. That rubber part should be checked now and then and replaced at least every five years. Read about a toilet that keeps running to fix it.
If the toilet itself rocks on the floor, read about the flange under the toilet instead.
Can I Just Tighten The Bolts?
It may work. The bolts can loosen over time, so try that first. Stop once they are firm, and do not let the tank touch the bowl.
How Do I Know If My Tank Leaks Into The Bowl?
Put a few drops of food colouring in the tank and wait 10 minutes. Colour in the bowl means a leak.
What Size Seal Do I Need?
Seals between the tank and bowl come in a 2 inch size and a 3 inch size. Check your toilet before you buy one.