How to install a sump pump depends first on whether your home already has a pit. You can put a pump into a pit that is already there with a few parts and some care. A new pit or a new foundation drain is a bigger job that needs permits and trained trades people, so have a plumber do it.
What You Need
Most pumps come with the main parts in the box. One maker says you will also need:
- You need rigid plastic pipe, 1 1/2 or 2 inches wide, to reach the pipe you have now.
- You need a check valve or a rubber union.
- You need pipe primer and cement for the plastic pipe.
Step 1: Make It Safe
Unplug the old pump before you start. Water and live wires can kill, so keep cords and plugs out of the water.
Step 2: Clean The Pit
Take out the old pump, and clean all the dirt and stones from the pit. The screen at the base of the new pump must stay clear.
Step 3: Give The Pump A Solid Base
Never set the pump right on a dirt or sand floor. Put bricks or a pump stand under it. That gives it a firm base and keeps it up away from the dirt.
Step 4: Connect The Pipe
Join the pump to the pipe that leaves the pit. Glue each plastic joint with primer and cement.
If you use a check valve, make sure the arrow on it points up. A valve put in upside down lets no water through. Read about a valve that bangs if yours is loud.
Some pumps also need a small hole, 3/16 of an inch wide, drilled into the pipe about 3 inches above the pump. It points down at a 45 degree angle and lets air out, so the pump does not air lock. Check your pump's guide to see if yours needs it.
Step 5: Check The Float
Make sure the float can move up and down without hitting the pit wall or the cord. If it catches, the pump may never turn on. See our guide to float trouble.
Step 6: Send The Water Away
The pipe should let the water out at least 1.8 metres from the house, onto a splash pad, in a spot where it will not run onto a neighbour's yard or freeze on a path.
In Peterborough, the City looks for sump pumps that are tied into the sanitary sewer, and it asks owners to remove them. Talk to the City about where your water should go.
Step 7: Test It
Plug the pump in, and pour a bucket of water into the pit. The float should rise, and the pump should start on its own and stop when the pit is low.
Help From The City Of Peterborough
The City of Peterborough has a Flood Reduction Subsidy Program. It can pay the full cost, up to $1,500, of a sump pit and pump the City says you need to cut your foundation drain off from the sewer. You must follow the Building Code and get all permits before the work starts, and you can call the City at 705-742-7777 to ask how to apply.
Can I Drain My Sump Pump Into The Sewer?
Ask the City first. In Peterborough, a sump pump tied into the sanitary sewer is one of the things the City asks owners to fix.
Do I Need A Permit?
Ask the City before you start. For work under the City's subsidy, you must get all permits and approvals before the work begins.
Should I Add A Second Pump?
A second pump in the same pit can take over if the main pump fails or the power goes out. Read how pumps that run on water pressure work.