A silent sump pump check valve has a spring and an angled seat, so it closes with less noise when the pump shuts off. Most valves make some sound as they close. A loud bang often means the pipe or pump is loose, so check those first. For any other pump trouble, get help with your pump.
What The Valve Does
The check valve is a one way valve on the pipe that leaves the pit. When the pump stops, the water in that pipe wants to fall back down. The valve shuts and holds it in the pipe, so the pump does not have to move the same water twice.
Read about how the whole system works if the parts are new to you.
Why It Bangs
A plain valve snaps shut as soon as the water starts to fall back. The sound is called water hammer. On a loose pipe, the whole line can shake and knock.
Check These First
- Make sure the pipe from the pump is held firmly in place.
- Make sure the pump sits firmly on the bottom of the pit.
- Make sure the arrow on the valve points up, in the way the water flows.
A valve that is upside down will not let any water pass. Fix that right away, because the pit cannot empty.
Swap In A Quieter Valve
If the bang is still loud, a valve with a spring can help. Here is how one maker's valve goes in:
- Turn the pump off so no water flows while you work.
- Take the old valve off the pipe.
- Measure the gap the new valve needs, and cut the pipe if you must. One maker's valve needs a gap of 5 1/8 inches.
- Set the valve between the two pipe ends, with rubber couplings on each end.
- Tighten the hose clamps on both couplings with a screwdriver.
Then turn the pump back on, and pour water into the pit to test it. Watch each joint for drips while the pump runs.
When To Call A Plumber
Call a plumber if the pit does not empty, if the pump keeps running after the pit is empty, or if the pipe leaks at a joint, since each of those can let water reach the floor. A plumber can also check the rest of the line while fitting a new pump.
Do I Need A Check Valve At All?
One pump maker says a valve is not required when the pump has its own pipe to the outside. A valve still keeps water from flowing back into the pit after the pump stops.
Can I Have Two Check Valves On One Pipe?
Some pump sets come with a valve already built in. One maker says to take out the old valve in that case, since an extra valve can slow the pump and cause an air lock.
What Is The Small Hole In The Pipe For?
One maker asks for a hole 3/16 of an inch wide, about 3 inches above the pump. It lets air out so the pump does not air lock. Water should spray from it while the pump runs.