East City Plumbing

How Does A Sump Pump Work? Pit, Float And Pump

East City Plumbing

How does a sump pump work? Water from the soil around your house drains into a pit under the basement floor. As the water rises, a float lifts and turns the pump on. The pump pushes the water up a pipe and out of the house. If your pump has quit, read about getting a pump running again.

The Drain Tile And The Pit

A pipe with small holes runs along the bottom of the foundation. It is called a weeping tile. It takes in water from the soil and carries it to the pit.

The pit is often where the sewer pipe comes into the house. Older homes, such as those built before the 1940s or 1950s, may not have a foundation drain at all.

The Float Turns It On

The float sits in the pit and rides up with the water. When the water lifts it high enough, the pump turns on. The pump keeps running while the water is above the float.

On some pumps, a timer keeps the pump going about 10 seconds longer, so the pit empties. Some pumps have 2 floats, and either one can turn the pump on.

When a float gets stuck, the pump stays off and the pit can overflow. Read more about a float that sticks.

The Pipe Takes The Water Away

The pump pushes the water up a pipe called the discharge line. A one way valve on that pipe stops the water from falling back into the pit when the pump shuts off. That valve can make a loud bang, and our guide to a valve that slams shows why.

Outside, the water should come out at least 1.8 metres from the house, onto a splash pad. Make sure it does not run onto a neighbour's yard.

What A Sump Pump Can And Cannot Do

A sump pump moves a small amount of water at a slow rate, which works well for a weeping tile but is far too slow to empty a basement that is flooding.

Most pumps run on power from the wall, so they stop in a power outage. A second pump in the same pit can take over. It can run on a battery, or on the water pressure in your home. See how pumps that run on water pressure work.

Test It With A Bucket Of Water

Pour a bucket of water into the pit. The float should rise, and the pump should start on its own. Check the maker's guide for any other care your pump needs.

Help From The City Of Peterborough

The City of Peterborough has a Flood Reduction Subsidy Program. It can pay the full cost, up to $1,500, of a sump pit and pump that the City says you need to cut the foundation drain off from the sewer. The work must be approved by the City before it starts. Call the City at 705-742-7777 to ask.

Should A Sump Pump Run All The Time?

It should run only when the water in the pit lifts the float. If it keeps running, check that the float switch is mounted straight and hangs freely.

Where Should The Water Go?

The water should come out on your own lot, at least 1.8 metres from the house. Use a splash pad so the water does not wear away the soil.

Why Do Some Older Homes Have No Sump Pump?

In many Canadian towns, the weeping tile used to be tied into the sewer pipe. That sends a lot of water into the sewer, and it can add to sewer backups.

Can A Sump Pump Empty A Flooded Basement?

It is too slow for a flood, since it is built to keep up with water from the weeping tile before that water reaches the floor.

Request A Visit

Tell us what you see and when it started, and say if water is still running, so we know how soon you need help.

Read how we handle your details in our privacy policy.

Online requests are not open yet.