East City Plumbing

Float Switch For Sump Pump: Stuck, Tangled Or Worn

East City Plumbing

Float switch for sump pump trouble can leave the pump off while the pit fills up. The float is meant to rise with the water and turn the pump on. If it gets stuck, the pit can overflow onto the floor. Test it with a bucket of water, and if the pump still will not start, get help with your pump.

What The Float Does

The float sits in the pit beside the pump. As water comes in, the float rises. Once it is high enough, it turns the pump on, and the pump runs while the water stays above it.

When the water drops, the pump shuts off. On some pumps, a timer keeps it going about 10 seconds longer so the pit empties. To see how the float fits with the rest, read how the pump and pit work.

How To Test It

Pour a bucket of water into the pit. The float should rise, and the pump should start on its own. When the water is gone, the pump should stop.

Water and live wires can kill. If the floor is wet or you are not sure what you are doing, call a plumber instead of reaching into the pit.

Stuck Low: The Pump Stays Off

A float can get caught on a wire, on dirt or on the side of the pit. Then it cannot rise, and the pump never turns on. Some pumps have a cage around the float to keep wires and dirt away from it.

Keep the pit clean, and make sure the cord is tied out of the float's way.

Stuck High: The Pump Keeps Running

A pump that runs nonstop may have a float that is not mounted right. One maker says to check that the round floats hang below the metal bracket and that the bracket is straight. A tilted bracket can hold the float up.

Two Floats And A Second Pump

Some pumps have 2 floats. Either one can turn the pump on, so if one fails, the other still works.

A second pump in the same pit adds cover, since its float sits higher than the main one, so if the main float sticks, the water lifts the second float and that pump starts. Read about pumps that run on water pressure as one choice.

How Do I Know If My Float Is Stuck?

Pour water into the pit. If the float does not rise or the pump does not start, the float may be stuck.

Why Does My Pump Keep Running After The Pit Is Empty?

A short run after the water drops is normal on pumps with a timer. On one maker's backup pump, it can last 25 to 60 seconds. If the pump runs much longer, check how the float is mounted.

Where Should The Float On A Second Pump Sit?

One maker says to mount it about 6 inches above the water line in the pit. Tie it firmly to the pipe with a plastic tie.

Request A Visit

Tell us what you see and when it started, and say if water is still running, so we know how soon you need help.

Read how we handle your details in our privacy policy.

Online requests are not open yet.