East City Plumbing

How To Repair Leaking Pipe Joint: Copper, Plastic And Push-Fit

East City Plumbing

How to repair leaking pipe joint drips depends on the kind of joint. Under a sink, a loose slip nut can often be snugged by hand. A push fitting can replace a bad joint on copper or plastic water pipe, while a soldered or glued joint that leaks is a job for a leak repair visit.

Shut Off The Water

For a water line, close the main valve before you touch the joint. Read how to shut off the water if you are not sure where the valve is.

Find The Joint That Leaks

Dry the pipes with a towel. Then look at each fitting for water on the outside of the pipe, since a drip can run along a pipe and fall from a lower spot.

If you cannot see a leak, read your water meter, use no water for 2 hours, and read it again. The US EPA says that if the meter moved at all, you probably have a leak.

Plastic Drain Joints With A Nut

The drain pipes under a sink are held together with slip nuts. Tighten a loose nut by hand, then give it 1 more quarter turn with pliers. Too much force can crack the plastic.

If it still drips, the washer inside may be worn. See the steps for a sink trap to change it.

Copper, PEX And CPVC Water Pipe

A push fitting is a brass part that slides over a pipe end and locks on with no solder or glue. One maker says its fittings work on copper, PEX, CPVC and HDPE pipe.

To use one, you cut out the bad joint, push a fitting onto each of the 2 pipe ends, and turn the water back on to check for drips. Read copper fixes without a torch for each step.

Joints That Need A Plumber

Call a plumber for a soldered copper joint or a glued plastic joint that leaks. Do the same for any joint inside a wall or ceiling, where you cannot see how much water has spread.

Can I Wrap Tape Around A Leaking Joint?

The US EPA's tip is for threads: on a shower head, a tight joint and pipe tape can fix some leaks. A slip nut under a sink seals with a washer and needs no tape.

Why Did A Joint Start To Leak After A Thaw?

The ice may have split the pipe or opened the joint. If a pipe leaks after it thaws, turn off the main valve and call a licensed contractor.

Can I Reuse A Push Fitting?

One maker says its fittings can be taken off with a disconnect clip and used again. It also says a fitting used many times should not go into a permanent job.

Request A Visit

Tell us what you see and when it started, and say if water is still running, so we know how soon you need help.

Read how we handle your details in our privacy policy.

Online requests are not open yet.