How to fix a leaking sink drain pipe starts with finding the joint that drips. Most sink drains are held together by plastic or metal nuts that you turn by hand. A loose nut or a worn washer is often the cause. If the leak is in the wall or the pipe itself, book a leak repair visit.
The Parts Under Your Sink
The pipe that drops from the sink is called the tailpiece. It goes into a U shaped bend, called the trap. A short pipe, called the wall tube, runs from the trap to the drain in the wall.
That makes 3 joints in all: the tailpiece to the trap, the trap to the wall tube, and the wall tube to the drain. Each joint has a slip nut and a washer. The washer makes the seal, and the nut holds it in place.
The trap always holds a little water. That water blocks sewer gas from coming into your home.
Find The Drip
Dry all the pipes with a towel. Then run the tap for 30 to 60 seconds, and watch each joint. Feel under each nut with a dry hand or a tissue.
Note where the water first shows up. A drip can run along the pipe and fall from a lower spot.
Snug The Slip Nut
If the drip is at a nut, tighten it by hand first. Then give it 1 more quarter turn with pliers. Run the water again to check.
Be careful not to tighten it too much. Too much force can crack plastic parts or strip the threads, and then the joint leaks worse.
Change A Worn Washer
If the nut is snug and the joint still drips, the washer may be worn or out of place. Here is how to change it:
- Put a bucket under the trap, since it is full of water.
- Loosen the slip nuts, lower the trap, and let the water drain into the bucket.
- Take off the old washers, and clean the ends of the pipes.
- Slide the nut onto the pipe first. Then slide on the new washer, with the tapered side facing the joint.
- Put the trap back, tighten each nut by hand, and finish with pliers if needed.
Washers come in sizes to fit the pipe, such as 1 1/4 inch and 1 1/2 inch. Bring the old one to the store so you get the same size.
These parts are made to be tightened by hand. You do not need any thread sealant. When you are done, run the water and check every joint again.
When To Call A Plumber
Metal nuts can get stuck. A little penetrating oil and gentle pressure may free them, but a badly rusted trap is often best replaced.
Call a plumber if the drip comes from the wall, from a crack in the pipe, or from a joint that still leaks after a new washer. For drips on supply pipes, read about leaks at a joint.
Why Does My Sink Drain Leak Only When I Run Water?
The drain only has water in it when the tap runs or the sink empties. A loose nut or worn washer lets some of that water out at the joint.
Do I Need To Turn Off The Water?
You do not need to for drain work, but do not use the sink while the trap is off. If you also move the supply lines, close the small valves under the sink first.
Can I Use Tape On A Slip Nut?
These joints seal with a washer, and they are made to be tightened by hand. No thread sealant is needed.
What If The Trap Is Cracked?
A cracked trap cannot be sealed with a new washer. Replace the trap, or call a plumber to do it.