East City Plumbing

How To Repair Leaking Copper Pipe Without Soldering

East City Plumbing

How to repair leaking copper pipe without soldering usually comes down to a push fitting. You cut out the bad spot, and a fitting grips the pipe ends with no torch or glue. If the leak is inside a wall or close to the ceiling, book a plumber's visit instead.

Shut Off The Water First

Close the main water valve before you cut anything. If you are not sure where it is, read how to shut off the water first.

What A Push Fitting Is

A push fitting is a brass part that slides over the end of a pipe and locks on. One maker says its fittings work on 4 kinds of pipe: copper, PEX, CPVC and HDPE. You do not need solder, glue or special tools.

A straight fitting called a coupling joins 2 pipe ends. These fittings can also go behind a wall or under the ground. If you bury one, wrap it in silicone tape first.

The Steps

  • Cut out the leaking spot. Make each cut clean and square, and keep the pipe free of scratches.
  • Smooth the inside and outside of each copper end with a deburring tool. A rough edge can make the fitting fail.
  • Use the gauge on the tool to mark how far the pipe must go into the fitting.
  • Push the fitting onto each of the 2 pipe ends, up to the mark.
  • Turn the water back on, and check each end for drips.

After A Cold Snap

The American Red Cross says water grows as it freezes, and that push can split a metal pipe. Some newer push fittings are made for fixing frozen copper pipe.

Look along the whole length of pipe before you fix the one spot you can see, since the same cold night may have reached other parts of that pipe as well. Read what happens when pipes freeze if the leak showed up after a cold night.

When To Call A Plumber

Call a plumber if the leak is at a soldered joint by the water heater, inside a wall, or on a pipe you cannot reach. A plumber can also check whether other parts of the pipe are thin.

Does The Pipe Have To Be Dry?

One maker says its fittings can go on wet pipe, even with water flowing. It is still easier and safer with the main valve closed.

Is A Push Fitting A Lasting Fix?

One maker calls its newer fittings a permanent fix and says they hold 2 times the burst pressure of its older ones. It also says a fitting that has been taken off and put back on many times should not be used for a permanent job.

Can I Take A Push Fitting Off Again?

Yes, a disconnect clip or tongs will release it.

Request A Visit

Tell us what you see and when it started, and say if water is still running, so we know how soon you need help.

Read how we handle your details in our privacy policy.

Online requests are not open yet.